What salt does to a condenser coil
A condenser rejects heat by passing air across hundreds of thin aluminium fins bonded to copper tube. Salt deposits sit in the gaps between those fins and hold moisture there long after the mist has passed. Aluminium does not rust the way steel does, but it corrodes, and a corroded fin loses the bond that lets it transfer heat.
The practical result is a unit that has to run longer to move the same amount of heat. You notice it as a system that used to cool a room in ten minutes taking twenty, or an outdoor unit that never seems to switch off on a mild day.
The parts that fail first
Coil fins are the obvious casualty, but they are rarely the first thing to stop the machine. On coastal call-outs we see a predictable order of failure:
- Condenser fins, which crumble at the edges and block airflow as they break down
- Fan blades and the screws holding the guard, which corrode and either seize or vibrate loose
- Bracket and plinth fixings, especially where mild steel was used instead of stainless
- Electrical terminal blocks and spade connectors, which oxidise and create resistance and heat
- Control boards on units exposed to wind-driven rain through a poorly sealed cover
- Drain pans, which corrode through and start dripping where the water lands
What genuinely helps
Nothing makes salt air disappear, but the rate of corrosion is something you can influence. Siting is the biggest lever: an outdoor unit tucked under a balcony overhang, or placed where onshore spray reaches it directly, will always fare worse than one in a sheltered position with free airflow.
Mounting the unit off the ground on a bracket or plinth keeps it out of splash and lets air move underneath. Washing the coil down with fresh water a few times a season removes the salt film, but only with the power isolated and only with a gentle spray rather than a pressure washer that folds the fins over.
Where a replacement unit is going in, coil coating options and stainless fixings are worth discussing. They add cost up front; on a west-facing wall a few hundred metres from the water, they often pay for themselves in service life.
A realistic rhythm for Big Bay
Visually check the outdoor unit once a month: look for white or chalky deposits on the fins, rust streaks on fixings, and debris trapped against the coil. Clear leaves and vegetation so air can get in.
Once a year, before the hot months arrive, have the coil cleaned properly and the electrical connections checked. If a condenser is already shedding fins across a significant part of its face, cleaning buys less each time and replacement becomes the better answer. A technician should tell you which of those two situations you are in rather than defaulting to another clean.