4 min read

A monthly cold-room check you can do yourself

Most cold-room failures announce themselves weeks before the room actually warms up. A ten-minute walk-round once a month catches the early versions of the faults that cost the most: iced evaporators, failing seals, blocked drains and condensers that cannot breathe.

Start with the numbers

Read the controller display and write the temperature and time down. A single reading tells you little; a series of readings tells you whether the room is holding its set point or drifting. If your controller keeps a minimum and maximum record, note those too.

Then look at the door seal with the door closed. Any visible gap, torn gasket or ice forming along the frame is worth acting on before it becomes a defrost problem.

The walk-round

Work through the same list every month so you notice change rather than just state:

  • Temperature reading logged against the set point
  • Ice or heavy frost on the evaporator, ceiling or floor
  • Water in the room, at the door or under the unit
  • Door seal condition, door alignment and closer operation
  • Condenser fins clear of dust, grease, leaves and stored goods
  • Unusual noise, vibration or a fan that sounds different
  • Controller alarms or fault codes, even if they have cleared
  • Strip curtain condition and door heater operation

What not to do yourself

Do not chip ice off an evaporator with a sharp tool. It is easy to puncture a coil, and a refrigerant leak turns a small defrost fault into a repair with a much bigger bill. Do not adjust controller settings to make an alarm stop, and do not keep resetting a unit that trips.

If the room is climbing and you cannot see why, move stock and call for help rather than waiting to see whether it recovers.

When to call instead of checking

Call when the temperature is above set point for more than a short defrost cycle, when ice is visible on the evaporator, when there is water on the floor, or when the compressor is running continuously without pulling the room down.

Bring the logged temperatures to the call. A short history of readings often shortens the diagnosis, because it shows whether the failure was sudden or had been developing.

Want this checked on your own system?

Send the details and we will tell you what the visit would cover, what it costs and when we can get there.

Request a quote

Tell us what is happening and we will come back with the next questions, then a scope and a price.

Goes to Reyds in Big Bay. We use your details only to respond to this enquiry.